Home » All » Troubleshooting » Vista » Windows | All Categories

Published on 09.10.08 by Brent Trahan


How-to troubleshoot the Stop Message: Stop 0x3F or NO MORE SYSTEM PTES.

The Stop 0x3F message indicates one or more of the following problems:

  • The System Table Entries (STE) are depleted or fragmented because the system is performing a high number of input/output (I/O) actions.
  • A faulty driver is not managing memory properly.
  • Software, such as a backup program, is improperly allocating a large amount of kernel memory.

Resolving the Problem

Before you can fix this problem you need to figure out what caused it. Did you recently install new software or hardware? This will help out a lot when troubleshooting the problem.

  1. Stop 0x3F messages can occur after you install faulty drivers or system services. If a driver is named in the message, try rolling it back to a previous version or uninstalling it. If a service is named in the message try to disable it. You might need to start Windows Vista in Safe Mode to disable the service.
  2. The system might not actually be out of PTEs, but a contiguous block of sufficient size may not be available to satisfy the driver or application. Check for updated drivers or software.

Still need help? Ask your computer question now.

Related Guides:

Leave a Reply

Subscribe to this guide's comments RSS feed.

Microsoft Windows is a registered trademark of Microsoft Corporation. Microsoft Corporation in no way endorses or is affiliated with MAXIMUMpcguides.com. All other products mentioned are registered trademarks of their respective companies. MAXIMUMpcguides IS NOT RESPONSIBLE for any damage or data loss to your computer from using this web site. All information on MAXIMUMpcguides is provided on an AS IS basis with NO WARRANTIES.

Copyright 2006-2019 Brent Trahan. All rights reserved.