Home » All » Troubleshooting » Vista » Windows | All Categories

Published on 09.11.08 by Brent Trahan


How-to troubleshoot the Stop Message: Stop 0x50 PAGE FAULT IN NONPAGED AREA.

A Stop 0x50 message indicates that requested data was not in memory. Defective memory (including main memory, L2 cache, and video card memory), or incompatible software (including antivirus and remote control software) might be the cause of 0x50 messages.

Resolving the Problem

Before you can fix this problem you need to figure out what caused it. Did you recently install new software or hardware? This will help out a lot when troubleshooting the problem.

  1. Run Windows Memory Diagnostics to see if it’s the memory causing this problem.
  2. If you recently installed new hardware lately, check and make sure it’s not the cause of this problem. Try removing or replacing it.
  3. 0x50 messages are also caused by faulty drivers. If a driver is named in the message, try rolling the driver back to a previous working version or uninstall it. You might need to boot Windows Vista in Safe Mode to uninstall the driver.
  4. System services can also cause 0x50 messages. If you recently installed software try uninstalling it or disabling services installed by it.
  5. Check your hard drive for errors. Run Check Disk to scan and fix problems on your hard drive.

Still need help? Ask your computer question now.

Related Guides:

Leave a Reply

Subscribe to this guide's comments RSS feed.

Microsoft Windows is a registered trademark of Microsoft Corporation. Microsoft Corporation in no way endorses or is affiliated with MAXIMUMpcguides.com. All other products mentioned are registered trademarks of their respective companies. MAXIMUMpcguides IS NOT RESPONSIBLE for any damage or data loss to your computer from using this web site. All information on MAXIMUMpcguides is provided on an AS IS basis with NO WARRANTIES.

Copyright 2006-2019 Brent Trahan. All rights reserved.